Technichal Problems and Hints for Solution

Over travel alarm which has been ocur by passing limit average can be interrupted by pushing ''P'' and ''CAN'' buttons to re-open machine.
Fort he machine which have absoulete axis specification for referance point definition ''APZ'' bit will be turn to ''0'' and after exis is brought to referance position machine has to be turned off/on .After turn on 1815 parameter ''APZ'' it will be turned to ''1'' and machine accepts existent position as referance.
For DAHLIH machines on unexpected positions of APC arm step by step using M81,M85 commands ATC arm is being moved.This process is established by using M1000,M1005 commands.
For arm type or umbrella type ATC arm units if tool changing position misses we take tool to change position and by turning ATC unit motor with hand we get arm close to spindle.We measure the missed length and by using 1850 parameter in micron values.When we change parameter we make machine power on/off .We ncan adjust tool changing position in this way.
Please never forget to take back up of your machine!
The most important side of CNC machines to work properly is truely adjusted parameters installed in NC unit.Some parameters and other data can change for needings of usage time by time.Because of inproper power source or wrong usage some parameters or all can be lost.After all repairment of machines parameter backups must be taken in case of any trouble in the future.Please consult our service department we surely try to do best in any case and any time.